A numerical study on the effects of EGR and spark timing to combustion characteristics and NOx emission of a GDI engine

EGR is one of the most significant strategies for reducing especially nitrogen oxides (NO_x) emissions from internal combustion engines. The thermal efficiency of spark ignition engines is lower than compression ignition engines because of its lower compression ratio. If the compression ratio is increased to obtain higher thermal efficiency, there may be a knocking tendency in spark ignition engines. EGR can be used in order to reduce NO_x emissions and avoid knocking phenomena at higher compression ratios. In-cylinder temperature at the end of combustion is decreased and heat capacity of fresh charge is increased when EGR applied. Besides EGR, spark timing is another significant parameter for reducing exhaust emissions such as nitrogen oxides, and unburned hydrocarbon (UHC). In this study the effects of EGR and spark timing on spark ignition engine were investigated numerically. KIVA codes were used in order to model combustion process. The combustion process has been modeled for a single cylinder, four stroke and gasoline direct injection (GDI) spark ignition engine. The results showed that in-cylinder pressure and heat release rate decrease as EGR ratio increase. In-cylinder pressure increases with the advancing of spark timing. Advancing spark timing increases the heat release rate and in-cylinder temperature. The simulation results also showed that EGR reduced exhaust gas temperature and NO_x emissions.     

Identifying and modeling key trade-offs between hydrogen fuel cell and electric vehicles

Through a sensitivity analysis, the trade-off between vehicle range and CO₂ emissions is investigated as a function of electric emissions coefficient. Various powertrains were analysed for use in a small crossover sport utility vehicle. Gasoline, gasoline electric hybrid, diesel, fuel cell and battery electric vehicles (BEVs) were considered. Using various upstream fuel pathways and a model for vehicle performance, emissions and energy use were estimated. The hydrogen fuel cell vehicle was found preferable to BEVs under conditions of high CO₂ emissions per kW-hr and a high vehicle range requirement. The BEV was preferable for all other conditions.     

An investigation on the fuel savings potential of hybrid hydraulic refuse collection vehicles

Refuse trucks play an important role in the waste collection process. Due to their typical driving cycle, these vehicles are characterized by large fuel consumption, which strongly affects the overall waste disposal costs. Hybrid hydraulic refuse vehicles offer an interesting alternative to conventional diesel trucks, because they are able to recuperate, store and reuse braking energy. However, the expected fuel savings can vary strongly depending on the driving cycle and the operational mode. Therefore, in order to assess the possible fuel savings, a typical driving cycle was measured in a conventional vehicle run by the waste authority of the City of Stuttgart, and a dynamical model of the considered vehicle was built up. Based on the measured driving cycle and the vehicle model including the hybrid powertrain components, simulations for both the conventional and the hybrid vehicle were performed. Fuel consumption results that indicate savings of about 20% are presented and analyzed in order to evaluate the benefit of hybrid hydraulic vehicles used for refuse collection.     

重庆市内环货车错时限行对空气质量的影响

在分析货车实施错时限行后内环车流量时段分布变化基础上,通过对PM_(2.5)、NO_2等指标的ADMS模型模拟和实际监测数据对比分析,探讨了内环货车错时限行对环境空气质量的影响。结果表明,货车错时限行后主城区环境空气中PM_(2.5)、NO_2小时平均质量浓度分别降低了9.4%和6.0%,峰值浓度明显降低,晚上出现峰值时间往后推移了2~3 h。经ADMS模型模拟计算,内环高峰时段机动车排放对主城区NO_2、PM、VOCs的浓度贡献分别降低了54.1%、56.3%、17.5%,CO浓度贡献不大。内环货车错时限行措施对重庆市主城区空气质量的改善有一定的积极作用。     

基于整车道路强化腐蚀试验的工况探讨

试验工况是否科学,可以通过对国内外常用试验方法的工况进行对比,发现其存在的差异性及侧重点,并通过调研对试验工况数据切合度进行验证。只有制定出合理的试验工况,才能为腐蚀数据库提供科学的数据支持。     

An experimental apparatus for testing biodiesels based on a CFR engine—setup and validation with different methyl ester blends

A cooperative fuel research (CFR) engine was modified and instrumented in order to control operating conditions and to measure engine parameters and in-cylinder pressure diagrams. Aiming at the comparison of different alternative fuels, an experimental procedure was defined, including cetane number (CN) evaluation and the definition of engine operating quantities in different working points, for fixed levels of compression ratio (CR) and injection advance. An investigation was made considering several blends of methyl-esters of rapeseed oil (RME) and of a mix of vegetable oils (VOME) with conventional diesel oil. The defined experimental procedure was applied to assess CN, engine brake thermal efficiency (bte) and exhaust emissions. Results show that the biodiesel content has a positive influence on soot emissions, with strong reduction, while thermal efficiency and NO_X emissions are negatively affected, which can be justified taking into account fuel properties and changes in combustion process. As observed outcomes are generally in line with those presented in literature, the facility proved to be a suitable tool for basic investigations on alternative fuels to be used in specific applications.     

浅议轮胎企业有机废气排放因子

介绍了AP-42、GB27632—2011中轮胎企业有机废气污染物情况,并与轮胎企业有机废气污染物实测数据进行比较分析,探讨了有机废气的排放因子。结果表明轮胎企业有机废气主要来自于炼胶、硫化工序,排放主要污染物为颗粒物、二甲苯、非甲烷总烃和二硫化碳,排放因子可参照AP-42确定。     

日本交通部门碳排放与低碳交通相关因素研究

本文就日本向低碳社会体系转型的过程中,交通部门碳排放现状、都市交通体系构成、实施对策等方面进行了分析,探讨其交通运输领域低碳交通的相关因素及发展模式,为中国低碳交通体系的构建提供参考。     

在用车I／M制度的脆性及脆性源研究

I／M制度作为一个系统存在着脆性源,如果该制度在运行过程中控制不好脆性源,则其有效实施将受到影响。利用系统脆性理论对该制度进行分析研究找出L／M制度系统的脆性源以及解决措施是其分析研究的目的。在系统子因子中从业人员素质、仪器设备是最大的脆性源,但是其均被维修企业和检测企业所包含。综合分析研究结果显示,由于其在维修企业的脆性度比在检测企业的脆性度大,所以维修企业是该制度最重要的脆性源。用系统脆性理论分析方法分析I／M制度的脆性是一种科学、有效和实用的方法,具有较好的应用前景,为保障更好的运行I／M制度以有效的控制在用车的排放提供了理论依据。     

基于实时交通信息的道路机动车动态排放清单模拟研究

以上海市为例开展了实际道路车流分布、行驶工况和车辆技术的实地调查,建立了道路车流、VSP分布和车辆技术数据库.在此基础上,基于实时的车流、车速等交通信息,构建了动态化的道路机动车污染物排放清单模拟方法,并开展了城区典型道路的机动车小时排放模拟案例研究.调查结果表明,上海市城区道路车流以轻型客车和出租车为主,分别占各时段车流总量的48%～72%和15%～43%;VSP分布与平均车速存在较好的规律,各车型VSP峰值随平均车速的上升向高负荷去移动,且峰值逐渐降低;当前上海市车辆以国2和国3车型为主,经过年检站调查结果的校正,国2和国3车型分别占各车型的11%～70%和17%～51%.模拟案例结果显示,道路机动车CO、VOC、NOx和PM日排放峰谷比可达3.7、4.6、9.6和19.8左右,CO和VOC排放主要来自轻型客车和出租车,与车流变化的相关性较好,而NOx和PM排放主要来自重型客车和公交车,且主要集中在早晚高峰时段.采用建立的动态排放模拟方法可实时反映实际道路的机动车排放变化,获取高排放路段和时段,为交通环境管理提供重要的技术手段和决策依据.